Motorbunny Jack Quick Start Guide - Motorbunny
Skip to content


๐Ÿ‡ Buy a Jack, get a FREE Fluffer Toy! Shop Now

Jack Quick Start Guide

Remote Control Guide

Remote Control Guide

Wireless Remote Controller Instructions:

  1. Power Button (โป):
    Long press for 2 seconds to power on and enter speed level .All LEDs light up simultaneously.Long press again for 2 seconds to power off; all LEDs turn off.
    Short press to pause operation (LEDs blink slowly). Press again to resume previous working status.
  2. Function Button (F)
    Short press to enter โ€œFixed Function Modeโ€ (synchronizes Motorbunny & Jack vibration modes).
    Each press cycles through fixed function modes.
    All 4 LEDs will flash once when switching, then remain lit.
  3. Speed Up Button (+)
    Short press to increase thrusting speed.
    LEDs will light up sequentially in a clockwise patternโ€”first one, then another, until all 12 levels are reached (each level adds 4 LEDs).
    Long press to quickly increase levels. Each level jump triggers 4 LEDs to light up clockwise.
    Once the desired level is reached, press response time and thrust interval: 0.3โ€“0.5 seconds.
    Note: LEDs light up in a clockwise loop, resembling a running light effect.
  4. Speed Down Button (โ€“)
    Short press to reduce thrusting speed.
    LEDs turn off one by one in counterclockwise orderโ€”returning to previous steady state.
    12 levels total. Long press for fast level decrease; each level jump causes 4 LEDs to turn off counterclockwise.
    Press response time: 1 second. Thrust interval per level: 0.3โ€“0.5 seconds.
    Must match level steps with speed increase.
  5. In speed mode, short press the Function button to enter or exit fixed function mode.
  6. If battery is low, all 4 LEDs blink rapidly.
  7. If no button is pressed for 30 minutes, LEDs will turn off automatically.
    If no operation for 60 minutes, device will shut down automatically.